[mythtv-users] SkyStar2 no scan/tune possible
Thomas Kuster
mythtv at fam-kuster.ch
Tue Jul 21 10:11:07 UTC 2009
Hello
I have a Skystar2 DVB-S card (see lspci [0]). This card worked perfectly with
my old VIA EPIA M board. Now I have switched to a Intel D945GCLF2 (CPU Atom
Dualcore) board. I use as before a Debian Lenny. But now I can not tune to a
channel in mythtv-setup and with scan [1].
The only errors I can see is this:
[ 7.696998] b2c2-flexcop: i2c master_xfer failed
[ 7.697776] b2c2-flexcop: i2c master_xfer failed
[ 7.697830] CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121)
see dmesg [2]
As before I have a DVB-T USB stick. This works without problem.
I tested also different kernel versions:
* vmlinuz-2.6.18-6-amd64
* vmlinuz-2.6.26-1-amd64
* vmlinuz-2.6.26-2-amd64
* vmlinuz-2.6.30.1tomix (from kernel.org with dvb from
http://linuxtv.org/hg/~pb/v4l-dvb/)
and Kubuntu (9.04 amd64 and i386) without any success.
I found that some have the same problems, but no solution. Some say it's just
a problem of the new version of the driver (but the missing line was in the
newest version), so this was not a solution. Other have a problem, if the
update to more RAM. This was also not my problem (I set the RAM to 512K with
grub). Any more ideas?
Sorry for my bad english.
Thomas
[0] lspci:
04:00.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB
chip / Technisat SkyStar2 DVB card (rev 02)
[1]
itix:/home/thomas$ scan -v -a 101 -d 0 -f 0 -s
1 /usr/share/dvb/dvb-s/Astra-19.2E
scanning /usr/share/dvb/dvb-s/Astra-19.2E
using '/dev/dvb/adapter101/frontend0' and '/dev/dvb/adapter101/demux0'
initial transponder 12551500 V 22000000 5
>>> tune to: 12551:v:1:22000
DiSEqC: switch pos 1, 13V, hiband (index 6)
DVB-S IF freq is 1951500
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x02
WARNING: >>> tuning failed!!!
>>> tune to: 12551:v:1:22000 (tuning failed)
DiSEqC: switch pos 1, 13V, hiband (index 6)
DVB-S IF freq is 1951500
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x01
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
>>> tuning status == 0x00
WARNING: >>> tuning failed!!!
ERROR: initial tuning failed
dumping lists (0 services)
Done.
[2] dmesg:
[ 7.376058] i801_smbus 0000:00:1f.3: PCI INT B -> GSI 19 (level, low) ->
IRQ 19
[ 7.445507] dib0700: loaded with support for 9 different device-types
[ 7.446774] dvb-usb: found a 'Hauppauge Nova-T Stick' in warm state.
[ 7.446997] dvb-usb: will pass the complete MPEG2 transport stream to the
software demuxer.
[ 7.447741] DVB: registering new adapter (Hauppauge Nova-T Stick)
[ 7.460294] Error: Driver 'pcspkr' is already registered, aborting...
[ 7.612365] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip
loaded successfully
[ 7.643032] flexcop-pci: will use the HW PID filter.
[ 7.643094] flexcop-pci: card revision 2
[ 7.643166] b2c2_flexcop_pci 0000:04:00.0: PCI INT A -> GSI 21 (level,
low) -> IRQ 21
[ 7.694196] DVB: registering new adapter (FlexCop Digital TV device)
[ 7.696528] b2c2-flexcop: MAC address = 00:d0:d7:12:ac:82
[ 7.696998] b2c2-flexcop: i2c master_xfer failed
[ 7.697776] b2c2-flexcop: i2c master_xfer failed
[ 7.697830] CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121)
[ 7.697884] CX24123: wrong demod revision: 87
[ 7.698600] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level, low) -> IRQ
22
[ 7.698747] HDA Intel 0000:00:1b.0: setting latency timer to 64
[ 7.704703] DVB: registering adapter 0 frontend 0 (DiBcom 7000PC)...
[ 7.891908] DiB0070: successfully identified
[ 7.892181] input: IR-receiver inside an USB DVB receiver
as /class/input/input6
[ 7.892367] dvb-usb: schedule remote query interval to 50 msecs.
[ 7.892422] dvb-usb: Hauppauge Nova-T Stick successfully initialized and
connected.
[ 7.892721] usbcore: registered new interface driver dvb_usb_dib0700
[ 7.985433] hda_codec: Unknown model for ALC662, trying auto-probe from
BIOS...
[ 7.996315] b2c2-flexcop: found 'ST STV0299 DVB-S' .
[ 7.996387] DVB: registering adapter 1 frontend 0 (ST STV0299 DVB-S)...
[ 7.996641] b2c2-flexcop: initialization of 'Air2PC/AirStar 2 ATSC 3rd
generation (HD5000)' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
[ 8.149511] usb-storage: device scan complete
More information about the mythtv-users
mailing list