[mythtv-users] How to "Apply" an Edit in editing mode

[Michael T. Dean]

On 09/05/2008 04:28 PM, Bobby Gill wrote:
> On Fri, Sep 5, 2008 at 4:19 PM, Michael T. Dean wrote:
>   
>> On 09/05/2008 04:12 PM, Bobby Gill wrote:
>>     
>>> I am just a bit confused about this, I have a program where I went
>>> into Edit Mode, set two cut points (delete before frame and then
>>> delete after frame, leaving desired space in between I want to trim
>>> down to), and I hit X as I have seen instructed in another thread. It
>>> doesn't show up in Job Queue, is it just going to take some time to
>>> cut out the parts and trim the recording down so I should check back
>>> later, or how does it work?
>>>       
>> Were you back in playback mode when you hit X?  (I.e. leave editing
>> mode, then hit X and see what happens.)
> I hit X and it sends me back to Watch Recordings from where I had played the
> recording. When I go back into the recording in question and hit E for edit
> mode, it says it's being edited and I can select continue editing or do not
> edit.

I'm suggesting:
e
<edit your cutlist>
Esc
x (while in playback mode)

Mike