[mythtv-users] Help installing HVR-1600, stuck

[Bobby Gill]

I am trying to install the HVR-1600 on my Mythbox which also has a PVR-150.
I have followed here:
http://www.mythtv.org/wiki/index.php/Hauppauge_HVR-1600#Installation_Guide

- Am I supposed to do that first part with the apt-get? I am using Arch
linux so I don't know how to get the latest driver, or if I'm supposed to
follow that at all? (Also says that latest drivers are included in kernel?)
- I downloaded the latest firmware as instructed and copied the .fw files to
/lib/firmware/, rebooted, and now I get this in dmesg:

~ # dmesg | grep cx18
cx18:  Start initialization, version 1.0.0
cx18-0: Initializing card #0
cx18-0: Autodetected Hauppauge card
cx18 0000:00:09.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
cx18-0: Unreasonably low latency timer, setting to 64 (was 32)
cx18-0: cx23418 revision 01010000 (B)
cx18-0: Invalid EEPROM
cx18-0: VBI is not yet supported
tuner 1-0043: chip found @ 0x86 (cx18 i2c driver #0-1)
tuner 1-0061: chip found @ 0xc2 (cx18 i2c driver #0-1)
cs5345 0-004c: chip found @ 0x98 (cx18 i2c driver #0-0)
cx18-0: Disabled encoder IDX device
cx18-0: Registered device video0 for encoder MPEG (2 MB)
DVB: registering new adapter (cx18)
cx18-0: frontend initialization failed
cx18-0: DVB failed to register
cx18-0: Registered device video32 for encoder YUV (2 MB)
cx18-0: Registered device video24 for encoder PCM audio (1 MB)
cx18-0: Registered device radio0 for encoder radio
cx18-0: Error -12 registering devices
cx18-0: Error -12 on initialization
cx18: probe of 0000:00:09.0 failed with error -12
cx18:  End initialization
~ #

Kinda stuck here, as I tried going into mythtv-setup and seeing if I might
be able to add the card but it only shows /dev/video0, of course my PVR-150.

Thanks
Bob
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20081026/6d2f75f9/attachment.htm