[mythtv-users] Diseqc not switching in Myth properly
OCG Technical Support
support at ocg.ca
Mon Mar 31 19:39:06 UTC 2008
I have 3 LNB's on my dish connected to a Diseqc connected to my sat card
(Hauppage Nova-S-Plus). When I use my Sat receiver I have no trouble
switching between the three ports. When I use scandvb from the linux
command line I have no trouble switching ports.
However, within myth I can only switch to ports 1 & 2 on the diseqc. (Port
3 shows now signal when scanned). Even stranger, my Sat receiver and
scandvb both show the same order of LNB's (port1=sat1, port2=sat2,
port3=sat3), but myth is (port1=sat 3, port 2=sat 1)...
What is going on? Since scandvb and my standalone receiver can operate the
hardware just fine, I assume this is a myth problem. (I'm running
0.20-fixes).
Thanks,
MD
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20080331/17d8e589/attachment-0001.htm
More information about the mythtv-users
mailing list