[mythtv-users] OT - Life without MythTV
Jay R. Ashworth
jra at baylink.com
Mon Feb 25 21:55:52 UTC 2008
On Mon, Feb 25, 2008 at 02:20:23PM -0500, Bill Omer wrote:
> You are correct. My set is a CRT rear projection. I believe the faulty
> component is the Flyback Transformer. I found one on partstore.com for
> about $50. I've been reading about some other people with this same set
> having this exact same problem, and for all them it seems like replacing
> the flyback was the solution. Unfortunately, it's soldered to a board
> and the power line to the tubes is *very* difficult to remove from the
> transformer. If I can figure out how to get that line out, I'll try to
> replace the transformer my self. If I screw it up, I also found an
> entire daughter board (with a flyback) on partstore for about $150
In general, the HV lead from the flyback to the tube(s) is not a
replaceable part: even if you can get it off, you probably can't
reliably get the new one on. And flybacks are where fires start in CRT
monitors. I'd buy the assembly, myself. But why can't you get the
Second anode lead off the *tubes*?
Cheers,
-- jra
--
Jay R. Ashworth Baylink jra at baylink.com
Designer The Things I Think RFC 2100
Ashworth & Associates http://baylink.pitas.com '87 e24
St Petersburg FL USA http://photo.imageinc.us +1 727 647 1274
Those who cast the vote decide nothing.
Those who count the vote decide everything.
-- (Joseph Stalin)
More information about the mythtv-users
mailing list