[mythtv-users] Channel/Card specific user job

Doug Haber doug at fawnanddoug.com
Fri Aug 1 21:00:45 UTC 2008

Hi Kevin,


Thanks for the quick reply.  I'm using the script from here:
http://mvpmc.wikispaces.com/transcoding and I was hoping there might be a
built in MythTV friendly way to do this without writing any code.  In the
worst case I can do that check, but I was hoping to not have to modify the


Any ideas?




p.s. In that worst case do you know what table has that info? I don't see
anywhere in the recorded table that shows the capture card that was used.


From: mythtv-users-bounces at mythtv.org
[mailto:mythtv-users-bounces at mythtv.org] On Behalf Of Kevin Kuphal
Sent: Friday, August 01, 2008 4:45 PM
To: Discussion about mythtv
Subject: Re: [mythtv-users] Channel/Card specific user job


On Fri, Aug 1, 2008 at 3:24 PM, Doug Haber <doug at fawnanddoug.com> wrote:

Hi all,


I was wondering if it was possible to configure myth such that any program
that gets recorded on channel A will cause user job "foo" to run for that
recording.  Or if that's impossible what about running user job "foo"
whenever a program is recorded via card B.

Can't your userjob script just using the information from the filename to
query the DB and figure out what card it was recorded on and act



-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20080801/7b080e79/attachment.htm 

More information about the mythtv-users mailing list