[mythtv-users] Determining 5C status on SA3250HD?

Eric Smith erictsmith at gmail.com
Thu Jun 7 21:06:13 UTC 2007


On 6/7/07, Bryan Mayland <bmayland at leoninedev.com> wrote:
>
> Dan Brown wrote:
> > I've seen two suggests in the archives, but neither works for me.  One
> > says to press the OK button on the STB remote until the mail light
> > starts flashing on the STB, and then press the Info button.  The other
> > suggestion uses the pause and pgup/down buttons, respectively.  When I
> > try either of these, I never get to the point of the mail light
> > flashing, even when holding down the respective button for 30-45
> > seconds.
> >
>     Are you pressing the OK button on the remote?  The way I know is to
> push the middle button (which is like ok, in the center of the
> directional buttons) on the STB itself.  Hold it in like 5 seconds until
> the light flashes then press info.
> _______________________________________________


When I had time warner there was also a "diagnostic channel" in the guide
(it might have been 611 for me, I don't remember).  If you went to a
channel, then to the diagnostic screen it would show you details about the
last channel you had been on, including encryption status.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20070607/cce49bee/attachment.htm 


More information about the mythtv-users mailing list