[mythtv-users] Security Cameras with motion sensor to record

Grant Swenson gswens at gmail.com
Sun Feb 12 04:45:21 UTC 2006


I've used motion with some success:
http://www.lavrsen.dk/twiki/bin/view/Motion/WebHome

On 2/11/06, Robert Tsai <rtsai1111 at comcast.net> wrote:
> On Sat, Feb 11, 2006 at 07:35:13PM -0500, Nathan Allen Stratton wrote:
> > I have several security camers connected to my mythtv system, I
> > mostly use the one in the baby room to check on my son, but I also
> > have one at the front and back doors of the house. I have motion
> > sensors connected to an HAI OmniPro system and can access that
> > system via my linux boxes. I would like to set it up so that the
> > front and back door cameras record for 5 min after the motion sensor
> > goes off. Is there a command I can send myth to record off a
> > specific card and channel for x min from the command line?
>
> You could try:
>
>         - Insert the appropriate SQL into your database (I'm guessing
>           the "record" table).
>
>         - Issue "mythbackend --resched" to signal the scheduler to
>           notice your new "schedule" and start recording.
>
> Probably straightforward (perhaps not trivial) to figure out the SQL,
> but once you get the script just right, it should work ...
>
> --Rob
>
>
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.4.1 (GNU/Linux)
>
> iD8DBQFD7o4n18A6pRrdKfkRAgBIAJ9n+pmKPm9eHRALTm91QFRuwRBlGQCdHwNd
> M74QZ98p39tI0NmFhhNEWu4=
> =uCbe
> -----END PGP SIGNATURE-----
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
>


More information about the mythtv-users mailing list