[mythtv-users] Edgy ivtv problems

Chuck Peters cp at ccil.org
Sun Dec 31 08:54:38 UTC 2006


I have a new PVR-150 card and its not being cooperative...
I followed the instructions at
https://help.ubuntu.com/community/Install_IVTV_Edgy
and my "cat /dev/video0 > /tmp/test2.mpg" test yields an empty file.
I tried installing the 386 kernel and reinstalling the ivtv driver to
see if it was a conflict with the nvidia driver, but that didn't help.

Any suggestions what to try next.


Thanks,
Chuck

[17179599.176000] ivtv:  ==================== START INIT IVTV
====================
[17179599.176000] ivtv:  version 0.7.0 (tagged release) loading
[17179599.176000] ivtv:  Linux version: 2.6.17-10-generic SMP
mod_unload 586 REGPARM gcc-4.1
[17179599.176000] ivtv:  In case of problems please include the debug
info between
[17179599.176000] ivtv:  the START INIT IVTV and END INIT IVTV lines, along with
[17179599.176000] ivtv:  any module options, when mailing the
ivtv-users mailinglist.
[17179599.224000] nvidia: module license 'NVIDIA' taints kernel.
[17179599.272000] ts: Compaq touchscreen protocol output
[17179599.416000] intel8x0_measure_ac97_clock: measured 58123 usecs
[17179599.416000] intel8x0: clocking to 48000
[17179599.420000] ACPI: PCI Interrupt 0000:02:08.0[A] -> GSI 20
(level, low) -> IRQ 217
[17179599.444000] e100: eth0: e100_probe: addr 0xfeafe000, irq 217,
MAC addr 00:07:E9:B9:65:D1
[17179599.444000] ivtv0: Autodetected Hauppauge WinTV PVR-150 card
(cx23416 based)
[17179599.460000] ACPI: PCI Interrupt 0000:02:02.0[A] -> GSI 18
(level, low) -> IRQ 169
[17179599.460000] ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
[17179599.512000] tveeprom 0-0050: Hauppauge model 26132, rev F0B2,
serial# 9400054
[17179599.512000] tveeprom 0-0050: tuner model is TCL M2523_5N_E (idx
112, type 50)
[17179599.512000] tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08)
[17179599.512000] tveeprom 0-0050: audio processor is CX25841 (idx 35)
[17179599.512000] tveeprom 0-0050: decoder processor is CX25841 (idx 28)
[17179599.512000] tveeprom 0-0050: has no radio, has IR remote
[17179599.612000] tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
[17179599.924000] wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
[17179600.112000] e100: eth0: e100_watchdog: link up, 100Mbps, full-duplex
[17179600.148000] sd 1:0:0:0: Attached scsi generic sg0 type 0
[17179600.608000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
[17179600.824000] ivtv0: Encoder revision: 0x02050032
[17179600.824000] ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
[17179600.824000] ivtv0: Allocate DMA encoder YUV stream: 194 x 10800
buffers (2048KB total)
[17179600.828000] ivtv0: Allocate DMA encoder VBI stream: 120 x 17472
buffers (2048KB total)
[17179600.828000] ivtv0: Allocate DMA encoder PCM audio stream: 455 x
4608 buffers (2048KB total)
[17179600.828000] tuner 0-0061: type set to 50 (TCL 2002N)
[17179600.828000] ivtv0: i2c hardware 0x00000001 not found for command
0xc008561c!
[17179600.828000] ivtv0: i2c addr 0x44 not found for command 0x4008646f!
[17179600.828000] ivtv0: i2c hardware 0x00000001 not found for command
0x4008646d!
[17179600.828000] ivtv0: i2c hardware 0x00000001 not found for command
0xc008561c!
[17179600.832000] ivtv0: i2c hardware 0x00000001 not found for command
0xc008561c!
[17179600.836000] ivtv0: i2c hardware 0x00000001 not found for command
0xc008561c!
[17179600.836000] ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
[17179600.836000] ACPI: PCI Interrupt 0000:01:00.0[A] -> GSI 16
(level, low) -> IRQ 185
[17179600.836000] NVRM: loading NVIDIA Linux x86 Kernel Module
1.0-8776  Mon Oct 16 21:56:04 PDT 2006
[17179601.136000] ivtv:  ====================  END INIT IVTV
====================


More information about the mythtv-users mailing list