[mythtv-users] Fusion 5 Tuning problems
Gary Manning
gmanning45 at hotmail.com
Wed Nov 23 16:22:25 EST 2005
On Tuesday 22 November 2005 09:16, David Ellis wrote:
> First off go into "Advanced Options" on your capture card in MythTV
> Setup, make sure your using TS Mode (not PS).
>
> Then, follow these steps:
>
> 1) Grab the frequency from you channels.conf (it will look like
> 525000000).
>
> 2) Add a new row to your dtv_multiplex table with the correct
> frequency, make sure the modulation is set to qam_256
>
> 3) Set the dtv_multiplex field of your channel in the channel_id to
> the id generated for you in 2. If you know the service id set it in
> serviceid field of your channels table.
>
> 4) Set the initial channel to tune in card input to a valid channel
> number - restart mythbackend.
>
> If you don't know the Service ID, run mythbackend with "-v all" and
> one of the debug messages includes all the service id's myth see's on
> the channel.
>
> David
Right now I have 2-3 (sub)channels in the channels table pointing to one row
(frequency) in the dtv_multiplex table, since they share the same frequency.
Could this be the problem?
Gary
More information about the mythtv-users
mailing list