[mythtv-users] OT: fc2 problem with 3 hd's

anders smith anders at smiths.dk
Thu Oct 28 14:33:31 UTC 2004


I'll give it a try with a new PS.... it's too bad it was really quiet.
thanks
anders

----- Original Message ----- 
From: "Tim" <t.tait at comcast.net>
To: "Discussion about mythtv" <mythtv-users at mythtv.org>
Sent: Thursday, October 28, 2004 3:55 PM
Subject: Re: [mythtv-users] OT: fc2 problem with 3 hd's


> anders smith wrote:
> 
> > I just encountered a problem yesterday where my otherwise well working 
> > fc2/0.16/pvr250/wilsonet.com box based on a via c3 processor suddenly 
> > wouldn't get past 'starting system loger' during boot.
> >  
> > The hd (maxtor 120gb diamondmax9) works fine in other myth box and was 
> > registered by the bios in the new box, but...
> > I tried with a IBM 70gb hd and it booted fine...
> >  
> > Any idea what is happening?
> >  
> > The box has a c3 at 600mhz, s50mb ram, soyo 7vem MB...
> >  
> >  
> > thanks
> > anders
> 
> I had a box just this week had a similar symptom (except it was Windows) 
> - turned out the 5V was quite low (4.5~4.7V) and the hard drive was 
> doing an undervoltage reset until the system warmed up. Needless to say 
> that 2yr old power supply (Antec TruePower 430 - bye-bye Antec) is no 
> good anymore.
> 
> Tim
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
> 


More information about the mythtv-users mailing list