[mythtv-users] 2 WinTV cards on Asus w/ VIA chipset
Jim Valavanis
jimvman at comcast.net
Tue May 25 22:42:37 EDT 2004
Tom Craddock wrote:
>Jim,
>
>What revision is the MCE card? If it's the 'Rosalyn' board, then it wont
>work with KnoppMyth as ivtv doesn't support is. Heres a link to a forum
>post in the SHSPVR IvyTV forums.
>
>http://www.shspvr.com/forum/viewtopic.php?t=4927
>
>HTH.
>
>Tom
>
>-----Original Message-----
>From: Scott Francis [mailto:scott.francis at newisys.com]
>Sent: Tuesday, May 25, 2004 5:01 PM
>To: Discussion about mythtv
>Subject: RE: [mythtv-users] 2 WinTV cards on Asus w/ VIA chipset
>
>Have you tried switching the ide slots that things are plugged into?
>
>Sorry, but that's the only thing I can think of.
>
>Scott
>
>-----Original Message-----
>From: mythtv-users-bounces at mythtv.org
>[mailto:mythtv-users-bounces at mythtv.org]On Behalf Of Jim Valavanis
>Sent: Tuesday, May 25, 2004 3:31 PM
>To: Discussion about mythtv
>Subject: [mythtv-users] 2 WinTV cards on Asus w/ VIA chipset
>
>
>Hello again everybody,
>
>I currently have an ASUS ASU-A7V8X-X with a WinTV 250 card and an NVIDIA
>GX440 and have been trying to install the new PVR-250MCE from ebay. I
>am aware of issues with the VIA chipset motherboards. I'm running
>knoppmyth 4.2. The system freezes or hangs when the card is being
>recognized at bootup, after an IRQ sharing message. No matter what I
>set the IRQ to, in the BIOS, on that PCI slot with the PVR250MCE, it
>seems to always share the IRQ with the NVIDIA card and always hang.
> I've tried passing some boot parameters like "noacpi" but the same
>thing happens. I've tried many different IRQ settings for each PCI
>slot, and moved the card around but still, it hangs.
>I can boot into single user mode without a problem.
>Any ideas on how to get the PVR-250MCE along with the WinTV250 to work
>together in this system?
>
>Thanks,
>
>Jim
>
>
>
>
>
>
>------------------------------------------------------------------------
>
>_______________________________________________
>mythtv-users mailing list
>mythtv-users at mythtv.org
>http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
OK now I'm not certain this is a PVR-250MCE. On the card itself is
printed....
Hauppauge NTSC/NTSC-J 32552 Rev B123
And I see the CONEXANT MPEG II A/V encoder chip CX23416-12.
From that link you sent
http://ivtv.writeme.ch/tiki-index.php?page=SupportedHardware I see on
the bottom that the Conexant Blackbird Design has that chip and is known
NOT to work.
Is this that type of card?
I received no documentation with the card just itself in static bag.
Jim
More information about the mythtv-users
mailing list