[mythtv-users] PVR250rev3 and the IR receiver?
mythtv at brtb.org
mythtv at brtb.org
Wed Mar 24 15:02:38 EST 2004
Nevermind... found the endianness fix after pre3. apparently i was going
to try pre4 and never did..... ugh.
brtb
On Wed, 24 Mar 2004 mythtv at brtb.org wrote:
> Anybody tried using the IR receiver on a new PVR250? CX23416 chip, model
> 32xxx sticker. Installed the lirc pre3 (tried pre4 as well), compiled
> fine, lirc-i2c modules load fine and syslog messages say it recognizes the
> i2c interface on the card. lircd loads without errors... but when i run
> irw, it's completely blank. Point the grey Hauppauge remote at it and get
> no output.
>
> Next stop is the LIRC list, but I figured I'd try here first.
>
>
>
More information about the mythtv-users
mailing list