[mythtv-users] PVR-250 MCE Not Working Following Jarod's Guide

[Nate Thompson]

 Below is the output of 'lspci -v':

01:08.0 Multimedia video controller: Conexant: Unknown device 8800 (rev 05)
        Subsystem: Hauppauge computer works Inc.: Unknown device 2801
        Flags: bus master, medium devsel, latency 32, IRQ 5
        Memory at e2000000 (32-bit, non-prefetchable) [size=16M]
        Capabilities: [44] Vital Product Data
        Capabilities: [4c] Power Management version 2

01:08.1 Multimedia controller: Conexant: Unknown device 8801 (rev 05)
        Subsystem: Hauppauge computer works Inc.: Unknown device 2801
        Flags: bus master, medium devsel, latency 32, IRQ 5
        Memory at e3000000 (32-bit, non-prefetchable) [size=16M]
        Capabilities: [4c] Power Management version 2

01:08.2 Multimedia controller: Conexant: Unknown device 8802 (rev 05)
        Subsystem: Hauppauge computer works Inc.: Unknown device 2801
        Flags: bus master, medium devsel, latency 32, IRQ 5
        Memory at e4000000 (32-bit, non-prefetchable) [size=16M]
        Capabilities: [4c] Power Management version 2

If I do a '/bin/dmesg |grep ivtv', I get the following information:

ivtv: version 0.1.9 (release) loading
ivtv: SGarray_size = 320, DSGarray_size = 16
ivtv: Error detecting PCI card

Any thoughts? This is rather frustrating. I should note that I tried to
install the card in my Windows box, and it would not install completely
either. Whenever I would try to install the Hauppague MPEG Encoder drivers,
it would give me a 'IVAC not found' error. I'm beginning to think my card is
defective.

Nate Thompson
-----Original Message-----
From: mythtv-users-bounces at mythtv.org
[mailto:mythtv-users-bounces at mythtv.org] On Behalf Of J. Donavan Stanley
Sent: Thursday, March 18, 2004 5:39 AM
To: Discussion about mythtv
Subject: Re: [mythtv-users] PVR-250 MCE Not Working Following Jarod's Guide

Nate Thompson wrote:

>At this point, I'm not sure what to do. The card is being seen by the 
>OS, and I'm somewhat new to using Linux. If anyone can offer any help, 
>I would greatly appreachate it. I've included some system specs below 
>just in case they might help.
>  
>

Did you follow the instructions about doing "lspci" and making sure the card
showed up on the bus?  What's the output of dmesg just after you try your
modprobe?
_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users