[mythtv-users] Via CLE266 (via-slice) HW acceleration problems(segfault)

[Ivan A. Beveridge]

On Wed, Jun 30, 2004 at 01:20:14PM +0200, Steven Cruysberghs wrote:
> I've set it up using the instructions on epiawiki.org
> epia kernel and the unichrome driver


> Do you have the libddmpeg compiled and installed?
> http://www.epiawiki.org/wiki/tiki-index.php?page=EpiaMpeg

Yup. It gets picked up OK (and the source-code line shows in the
backtrace, IIRC).

> The via_v4l module uses devices video0, video1 and video2
> Your tvcard has to be setup to use /dev/video3 and you have to change your
> mythsetup to use this device.

It's a DVB card, so I escape that bit :)

I have now modified my modprobe.conf entry to load the via_v4l_drv
before the rest of the bttv stuff, but that doesn't seem to have made
any difference (still segfaults). I have also tried putting the agpgart
& v4l drivers in /etc/modules instead, but none of this worked. It 
still has the same problem :(

Cheers


Ivan
-- 
Ivan Beveridge	<ivan at dreamtime.org>