[mythtv-users] IR-200L Help
Cory Megitt
mythtv at cable.megitt.com
Wed Aug 11 22:19:16 EDT 2004
Can anyone offer any advice as to how to get change_channel.csh to actually
change the channel or elaborate on what I might be doing wrong?
-----Original Message-----
From: mythtv-users-bounces at mythtv.org
[mailto:mythtv-users-bounces at mythtv.org] On Behalf Of MythTV
Sent: Monday, August 09, 2004 11:17 PM
To: Discussion about mythtv
Subject: [mythtv-users] IR-200L Help
I managed to run: remote_irrecord --device=/dev/remote filename and the dots
appear so I know that the IR Blaster is receiving signals from the
Scientific Atlanta remote.
It generated a conf file with the following data, however, when running
change_channel.csh 13 as per the directions, it does not change the channel.
A new PID number gets generated though.
Here's the output of the file remote_irrecord generated.
begin remote
name filename
bits 23
flags SPACE_ENC|CONST_LENGTH
eps 30
aeps 100
header 3329 3350
one 832 2510
zero 832 855
gap 100299
toggle_bit 0
begin codes
end codes
end remote
-------------
This data differs slightly from my /etc/remoted.conf file.
begin remote
name SA2000
flags CONST_LENGTH|RAW_CODES
eps 30
aeps 100
ptrail 0
repeat 0 0
gap 100240
Should I adjust the remoted.conf file to accomodate the additional info that
was created?
I am using a Scientific Atlanta E2050ER1 remote, along with a 3200 model
receiver.
_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
More information about the mythtv-users
mailing list