[mythtv-users] ivtv and stereo sound.

[Joe Byrne]

It turns out the DEU is bad.

DEU=dumb end user.  Yes, a cable had pulled out.  Duh!  I thought I had
tested that.

----- Original Message ----- 
From: "Ajay Sharma" <ssharma at amntv.com>
To: "Discussion about mythtv" <mythtv-users at mythtv.org>
Sent: Tuesday, October 14, 2003 9:45 AM
Subject: Re: [mythtv-users] ivtv and stereo sound.


> On Mon, 2003-10-13 at 23:06, James L. Paul wrote:
>
> > |>Was there any resolution to this?  I, too, find that my PVR-250
(Freestyle
> > |>bought off Ebay) only gets the right channel.
>
> Umm... since I started the post I guess I'll close it.  I was only
> getting audio from the right channel and then I went to check my cables
> and sure enough the audio (coming from the satellite receiver) was
> loose.  So I pushed it in and now I'm only getting audio from the left.
> I didn't spend much time on the problem after that since it's obviously
> a cable problem on my end.
>
> > I test the card output with "mplayer /dev/video0" and my audio portion
> > of the info shows:
> >
> > Opening audio decoder: [mp3lib] MPEG layer-2, layer-3
> > MP3lib: init layer2&3 finished, tables done
> > AUDIO: 48000 Hz, 2 ch, 16 bit (0x10), ratio: 48000->192000 (384.0 kbit)
> > Selected audio codec: [mp3] afm:mp3lib (mp3lib MPEG layer-2, layer-3)
>
> I tried this and even though I only get audio from the left channel, it
> still says "AUDIO: 48000 Hz, 2 ch", so there's no problem with my card.
>
> So the solution, IMO, is double check your cables.  At least I know
> that's the problem with my setup.
>
> later,
> ajay
>
>