[mythtv] Per Channel post processing setting?

Wim Fokkens wimfokkens at planet.nl
Sun Jul 16 19:01:20 UTC 2006

> -----Oorspronkelijk bericht-----
> Van: mythtv-dev-bounces at mythtv.org [mailto:mythtv-dev-bounces at mythtv.org]
> Namens Michael T. Dean
> Verzonden: woensdag 12 juli 2006 2:40
> Aan: Development of mythtv
> Onderwerp: Re: [mythtv] Per Channel post processing setting?
> On 07/11/06 19:08, Bruce Markey wrote:
> >Michael T. Dean wrote:
> >...
> >
> >
> >>TTBOMK, there is no "per channel post processing" setting.
> >>
> >>
> >Your knowledge is pretty good but I don't know why you didn't know
> >that Donovan added playback filters for the situation where hardware
> >encoded files needed filtering which could only be imposed during
> >playback.
> >
> >Go to mythtv-setup Channel Editor. near the bottom of the first
> >page is "Playback filters:" just below "Video filters:". Both
> >Video filters (applied before compression with software encoding)
> >and Playback filters (applied after decoding recordings from that
> >channel during playback) can include any of the filters described
> >in the HOWTO (other than bob).
Ok but this is on the backend so this will apply to all my frontend's. This
is problem because I have only one frontend that is powerful enough to do a
lot of post processing (pentuim d805). My 2 other frontend's (Celeron 800 &
900) will choke if I set to much post processing here.

> >
> >http://www.mythtv.org/docs/mythtv-HOWTO-10.html#ss10.4
> >
> >You can also apply per frontend filters which applies to all reocrdings
> >in Setup->TV Settings->Playback. This is where bob or other deinterlace
> >filters can be set but you could also add other "Custom Filters".
Ok but this settings apply to all channels and I don't want to apply post
processing on channels that are good quality or HD channels.

I think all these setting are great but are in the wrong place. I think I
would be best to have per channel settings on the frontend.


> >
> Wow.  I knew about the per-frontend playback filters, but didn't realize
> you could specify them on a per-channel basis.  Good to know--and I
> guess I need to spend more time in mythtv-setup.  :)  Thanks for the
> correction.
> Mike
> _______________________________________________
> mythtv-dev mailing list
> mythtv-dev at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev

More information about the mythtv-dev mailing list