[mythtv] [PATCH] QT3.3 Required Now? scanwizard.cpp
Christian Hack
christianh at edmi.com.au
Sun May 22 05:51:43 UTC 2005
Without often using the setup tool, I'm not 100% sure what you're wanting me
to test.
Using the 3rd patch:
1) Compiled no problem as a debug version - although you probably knew that
(I had to fudge it to get past mythuitest because it was failing to find a
library though)
2) The scanning tool correctly detected all 5 FTA frequencies and all the
individual channels contained within.
I'm not sure where it should be "auto-detecting" the country from.
Is that what you wanted to know? I'm not sure it is.
CH
> -----Original Message-----
> From: mythtv-dev-bounces at mythtv.org
> [mailto:mythtv-dev-bounces at mythtv.org] On Behalf Of John Pullan
> Sent: Sunday, 22 May 2005 12:03 AM
> To: Development of mythtv
> Subject: Re: [mythtv] [PATCH] QT3.3 Required Now? scanwizard.cpp
>
>
> Tidied it up a bit more (hopefully this should be it)
>
> On 21/05/05, John Pullan <john.pullan at gmail.com> wrote:
> > Try again :|
> >
> > On 21/05/05, John Pullan <john.pullan at gmail.com> wrote:
> > > On 21/05/05, Christian Hack <christianh at edmi.com.au> wrote:
> > > > I've been away for a while - is QT3.3 required now for CVS?
> > > >
> > > > Scanwizard.cpp as of May 15 won't compile due to
> "qlocale.h" being not
> > > > available in QT3.2. It appeared in QT3.3.
> > > >
> > > The code auto tries to auto select which country you are in for a
> > > DVB-T full scan.
> > > The attached patch should alliviate the problem for you
> while keeping
> > > the functionality in. If you could test it and report
> back that would
> > > be good :)
> >
>
> --
> John
>
More information about the mythtv-dev
mailing list