[mythtv] dvb-c channel scanning

Torbjörn Jansson torbjorn.jansson at mbox200.swipnet.se
Wed Jun 22 17:58:01 UTC 2005

When doing a "Full scan of existing transports" from mythtv-setup it doesn't
pickup new transports.
Maybe that's how it's supposed to do?
If i want to be sure i get new transports i have to use full scan and enter
a frequency and symbol rate or whatever it was called?

The reason i ask is because when i did a full scan of existing trasnports it
didn't pickup the 2 new transports.

And i just tested to do a "Full Scan (Tuned)" and enter the frequency
322000000 and 6875000 for symbol rate.
The setup program prints:

<many lines like below cut>
2005-06-22 19:28:43.039 DVB#0 DVB signal ffff | snr a7a7 | ber 9ffff6 | unc
ffff ffff
2005-06-22 19:28:43.993 DVB#0 DVB signal ffff | snr adad | ber 9ffff6 | unc
ffff ffff
2005-06-22 19:28:44.923 DVB#0 DVB signal ffff | snr abab | ber 9ffff6 | unc
ffff ffff
2005-06-22 19:28:45.547 DVB#0 WARNING - Status: NO LOCK!
2005-06-22 19:29:38.131 DVBSignalMonitor::Stop() -- begin
2005-06-22 19:29:38.134 DVBSignalMonitor::Stop() -- end
2005-06-22 19:29:38.135 DVB#0 CA: CiHandler thread stopped

And then the setup program said it failed to tune.
The setup program says the signal is at 100% so it shoud be able to get a

Coud this be another problem/bug with the changes daniel (or whoever it was)
did to the dvb code about a week or so ago?

More information about the mythtv-dev mailing list