[mythtv] firewire mpeg2ts input

[Jim Westfall]

Can you give the output of gscanbus and 6200ch?  Every DCT-6200 device I 
have seen thus far has been node 2.

jim

DavidB <mythtv at TheBlains.net> wrote [02.02.05]:
> Jim,
> 
> First off, Great Work!
> 
> I am trying to get the firewire working and have not had any success. Here
> is what I have done to this point:
> 
> 1) Downloaded libraw1394 version 1.1.0 source, compiled and installed.
> 2) Pulled down the trunk source for libiec61883 revision 49, compiled and
> installed.
> 3) Re-compiled 6200ch to use new libraw1394 and tested.  (I have been using
> this to change channels for a few months)
> 4) Pulled down current CVS as of 11:00am today. Compiled, installed, and ran
> setup.  
> 5) Configured a new Capture Card and selected port 0, node 1 (used gscanbus
> and 6200ch -v to get values)
> 
> When I manually schedule a program for a local channel I get the following
> in the log file:
> 	
> 2005-02-02 14:04:36.657 FireWire: Initializing Port: 0, Node: 1, Speed:
> 100Mbps
> libiec61883 warning: Overlayed connection on channel 0.
> You may need to manually set the channel on the receiving node.
> 2005-02-02 14:04:36.661 FireWire: Created Channel: 0, Bandwidth Allocation:
> 0
> 2005-02-02 14:04:36.661 FireWire: Changing Speed 200Mbps -> 100Mbps
> 2005-02-02 14:04:51.656 Firewire: No Input in 15 seconds [P:0 N:1] (select)
> 
> Is there anything that I can use to determine if everything is configured
> correctly? 
> 
> As a note: I am doing all this work through an ssh session so I can only
> test by scheduling a recording through mythweb.
> 
> Any help would be appreciated. Thanks,
> 
> David
> 
> 

> _______________________________________________
> mythtv-dev mailing list
> mythtv-dev at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev