[mythtv] settings profile and transcode issue
Vinton Coffman
vintonc at redzone.com
Sat Sep 27 17:53:52 EDT 2003
I most likely don't have something set right but here's the error.
2003-09-27 16:27:31 Transcoding from
/home/mythtv/video/1060_20030926200000_20030926210000.nuv to
/home/mythtv/video/1060_20030926200000_20030926210000.nuv.tmp
Input #0, mpeg, from
'/home/mythtv/video/1060_20030926200000_20030926210000.nuv':
Stream #0.0: Video: mpeg2video, 480x480, 29.97 fps, 8000 kb/s
Stream #0.1: Audio: mp2, 48000 Hz, stereo, 384 kb/s
Couldn't find profile for : MPEG-2
2003-09-27 16:27:32 Transcoding
/home/mythtv/video/1060_20030926200000_20030926210000.nuv failed
I thought I had the setting correct but these still some odd behavior
in "Recordings Profile"
Enter "Recordings Profiles"
pick MPEG-2 Encoders (PVR-250, PVR-350)
I get a very large dark blue box with "MPEG-2 Encoders (PVR-250,
PVR-350)" at the top of the screen just about the box.
hit space again and then I get the normal screen with Profile name:
(which is blank) Does it need to be set?
hit space again width and height are set correctly
hit space again. Here's the odd part. The codec is always reset to
RTjpeg. I use Hardware MJPEG. I'm not sure if the settings are
sticking when I change them or if Recordings Profiles is ignoring them
when reloading.
Did the default audio settings for the PVR-250 change? They were 48000
and now appear to be 44100. So I would need to change this to
transcode old 48 kHz file vs the new 44.1 kHz audio, correct?
After hitting space for the "Finish" button I see the large blank blue
square. If I hit space again it takes me back into the recording
profile I was just editing. It I hit escape, it takes me back to the
list of profiles. Escape again exits normally to the previous screen.
So what's with the big blue box and is it not remember the settings or
just not display what they're currently set to?
Thanks,
Vinton
More information about the mythtv-dev
mailing list