[mythtv] Poll: System Requirements
Allen T. Gilliland IV
Wed, 20 Nov 2002 00:25:39 -0800 (PST)
multcount = 16 (on)
IO_support = 1 (32-bit)
unmaskirq = 1 (on)
using_dma = 1 (on)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 8 (on)
geometry = 9729/255/63, sectors = 156301488,
start = 0
Timing buffered disk reads: 64 MB in 2.91 seconds =
Timing buffer-cache reads: 128 MB in 1.03 seconds
not sure if there is anything else to do.
I also noticed a strange thing as well ... hitting
<enter> in mythepg doesn't change the channel for me,
only <m> works from the epg. Strange.
--- Ray <firstname.lastname@example.org> wrote:
> On Tue, Nov 19, 2002 at 11:42:16AM -0800, Allen T.
> Gilliland IV wrote:
> > This is almost a bit disheartening.
> > Here's my setup:
> > Athalon 1200MHz - 512MB SDRAM
> > 80GB Seagate IDE 7200rpm
> > WinTV dbx 401
> > SB awe64 isa
> > Leadtek GeForce2 MX 400
> > Gentoo 1.4
> > mythtv 0.7
> > hdparm test = 17.11 MB/sec (i think this is
> limited my
> > my m/b to UDMA66)
> That disk speed seems pretty slow, are you sure you
> have dma enabled? My
> Dual Celeron box has a pair of 7200rpm Maxtors. The
> one connected to the on
> board udma33 controller gets around 27MB/s and the
> one connected to a
> Promise udma66 controller gets around 36MB/s.
> mythtv-dev mailing list
Do you Yahoo!?
Yahoo! Web Hosting - Let the expert host your site